Zolokasa Customers should obtain the latest relevant sn74ls06n datasheet before placing orders and should verify that such information is current and complete. Use of such information may datashete a license from a third party under the patents or other intellectual property. Texas Instruments Incorporated and its subsidiaries TI reserve the right to make corrections, modifications. Resale of TI products or services sn74ls06n datasheet statements different from or beyond the parameters stated by TI for that. Resale sn74ls06n datasheet TI products or services with statements different from or beyond the parameters stated by TI for that product or service voids all express and any implied warranties for the associated TI product or service and is an unfair sn74ls06n datasheet deceptive business practice.
|Published (Last):||24 July 2013|
|PDF File Size:||8.34 Mb|
|ePub File Size:||20.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to the IR LED and the other to Photo-transistor. The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two. This comes in very handy when you are trying to isolate a noisy signal from your digital electronics, so if you are looking for an IC to provide optical isolation in your circuit design then this IC might be the right choice for you.
Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit. The Emitter pin 4 is grounded. This is where the isolation occurs. There pull-up resistor 1K acts as a load resistor. But when the Logic input is made high, this high voltage should be a minimum of 1. This will short the collector and emitter and hence the Logic Output voltage will become zero. This way the logic input will be reflected at the logic output and still provides and isolation between the two.
The complete working can also be understood form the GIF file above. Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf. The output will not get high as soon as the input logic is made low and vice versa.
The below waveform shows the time taken for the output to transit from one state to another.
SN74LS06N DATASHEET DOWNLOAD